發(fā)布時(shí)間：2025/6/29 8:59:00
The inhouse electrician needed a wire Spool holder so I made this out of 3/16 steel. You could go 3mm / .119" with no problem but I would remove or etch the bend lines. I use them for cuts as I do not have a press break and I end up bending my stuff by hand lol.
|
共個(gè)文件
壓縮包大?。?34KB
|
||
|---|---|---|
微信小程序
微信掃碼打開(kāi)此模型
迪威模型
微信掃碼支付